Filter
Top Products
HOW TO SET UP YOUR PRESSURE WASHER
(continued)
• Cut the fie wraps on the High Pressure Hose and
connect to Spray Gun. Tighten by hand.
• Place assembled spray gun on holder.
• Remove plastic cap and connect High Pressure
Hose to Pump. Tighten by hand.
Attach High
Pressure
Hose here
Attach nozzle extension to spray gun.
Attach adjustable nozzle to the nozzle extension.
• Place turbo nozzle in grommet hole in base.
PRE-OPERATIONAL CHECKLIST
Before you operate your new high pressure washer
please review the following items:
• All assembly instructionshave been completed.
• The high pressure hose connections to the spray
gun and to the pump are tight and secure.
• Engine oil is at proper level
Important: Any attempt to crank or start the engine
before it has been serviced with the recommended oil
may result in an engine failure. See Page 9 for basic
instructions on adding oil and proper oil specifications
for your high pressure washer.
• Be sure gas tank is filled properly with clean, fresh,
unleaded gasoline.
• Become familiar with all controls - their location
and function. Operate those controls before
starting the engine.
Important: The water supply to your high pressure
washer must be connected and turned on prior to
starting your engine.
.5