Filter
Top Products
Yourpressurewasherrequiressomeassemblyandis
readyfor useonlyafterit hasbeenproperlyserviced
withtherecommendedoilandfuel.
Ifyou have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3t 36.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
1,
2,
3.
4.
Slice two corners opposite guide handle end of
carton from top to bottom so panel can be folded
down flat.
Remove fillers, accesories and parts bag shipped
with your pressure washer.
Roll _ressure washer out open end of carton.
Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
Main Unit
Handle
Plastic Accessory Tray
High Pressure Hose
Spray Gun
Hose Reel
Turbo Nozzle with Quick Connect Fitting
Nozzle Extension with Quick Connect Fitting and
Spray Tip Holder
Oil Bottle
Parts Bag (which includes the following):
Owner's Manual
Owner's Registration Card
Bag containing 4 multi-colored Quick Connect
Spray Tips
Handle Fastening Hardware Kit (which includes):
Carriage Bolt
++L_ Bolt
Plastic Knobs (2)
++J'Hook
Chemical Hose Clip
Self Tapping Screws (4)
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Fill out and send in registration card.
2. Attach accessory tray to handle, then attach
handle to main unit.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and
pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect spray tip to nozzle
extension.
9. Attach hose reel according to instruction sheet
included in hose reel box.
Attach Handle and Accessory Tray
NOTE: All assembly operations given in this section
will be described from the perspective of assembling
the pressure washer from the rear.
1. Slide plastic accessory tray onto handle and align
holes in accessory tray with holes on handle.
/
2. Secure tray to handle with self tapping screws
using a #2 phillips screwdriver. Ensure screws are
tight but not crushing the plastic accessory tray.
3. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
6