Filter
Top Products
How to Stop Your Pressure Washer
Move variable pressure control lever on engine to
"Stop" position.
Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when
you release the pressure.
How to Use Accessory Tray
The unit is equipped with an accessory tray with places
to store your nozzle extension and turbo nozzle, and
slots to hold the cleaning solution bottle and the
detergent siphoning filter. There are also two hooks at
the ends of the handle to hold your spray gun.
1. Place nozzle extension through hole on accessory
tray as shown.
2. Hang chemical solution bottle on ++J"hook and
place detergent siphoning filter in last slot on left.
3. Place turbo nozzle in the last slot on right in tray.
4. Place spray gun on hook attached to accessory
tray on right side of unit.
How to Use Spray Tips
The quick-connect on the nozzle extension allows you
to switch between four different spray tips. The spray
tips vary the spray pattern as shown above.
latChon the _figger,
Follow these inst_ucUons to change spray tips:
1. Engage safety latch on spray gun.
2. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
3. Select desired spray tip:
For gentle rinse, select white 40 ° spray tip.
To scour surface, select yellow 15° or red 0°
spray tip.
To apply chemical, select black spray tip.
Low Pressure
Black
Use to apply
chemical
4,
5.
40_ White
High Pressure
YY
15+ Yellow 0" Red
Pull back on collar, insert new spray tip and
release collar. Tug on spray tip to make sure it is
securely in place.
For most effective cleaning, keep spray tip from
8 to 24 inches away from cleaning surface. If you
get spray tip toe close, you may damage cleaning
surface. DO NOT get closer than 6 inches when
cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern. Always start the turbo nozzle at
a distance, gradually getting closer to the surface until
you get the cleaning force you want.
1. Pull back collar on quick-connect and pull current
spray tip off. Store spray tips in holder provided on
the nozzle extension.
2. Pull back on collar, insert turbo nozzle and release
collar. Tug on turbo nozzle to make sure it is
securely in place.
3. For most effective cleaning, keep turbo nozzle
from 8 to 24 inches away from cleaning surface. If
you get turbo nozzle too close, you may damage
cleaning surface.
NOTE: Detergent cannot be applied with the turbo
nozzle.
Cleaning and Applying Chemical
IMPORTANT: Use chemicals designed specifically
for pressure washers. Household detergents could
damage the pump.
10