Filter
Top Products
Yourpressurewasherrequiressomeassemblyandis
readyforuseonlyafterit hasbeenproperlyserviced
withtherecommendedoil andfuel.
if youhaveanyproblemswiththeassemblyof
yourpressurewasher,pleasecall the pressure
washerhelplineat 1-800-222-3136.
iMPORTANT:Anyattemptto runtheenginebeforeit
hasbeenservicedwiththerecommendedoilwillresult
inanenginefailure.
REMOVE PRESSURE WASHER
FROM CARTON
• Slice two corners opposite guide handle end of
carton from top to bottom so the panel can be
folded down flat.
• Remove fillers, accesodes and parts bag shipped
with your pressure washer.
• Roll the pressure washer out the open end of the
carton.
• Check carton for additional loose parts.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
The main unit
Handle
Spray gun
High pressure hose
Nozzle extension with Hi/Lo adjustable nozzle
Engine oil
Parts bag (which includes items listed below)
Owner's manual
Registration card
Handle attachment hardware
Become familiar with each piece before assembling
the pressure washer. Check all contents against the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman high pressure washer was mostly
assembled at the factory. However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Attach handle.
2. Add oil to engine crankcase.
3. Add fuel to fuel tank.
4. Connect pressure hose to spray gun and pump.
5. Connect water supply to pump.
Attach Handme
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
f
/ i
_ // Handle i"
Align Holes,_i '__
_] Handle i
// Supports l
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach a plastic knob from inside of unit.
Tighten by hand.
.
Insert one "L" hooks through hole just under
billboard on left side of handle (viewing from rear
of unit). Hold hook in place and attach plastic knob
from inside of unit. Tighten by hand.
.
I
Hose Hook
Insert other "L" hook through hole just above
billboard on right side of handle (viewing from rear
of unit). Hold hook in place and attach plastic knob
from inside of unit. Tighten by hand.