Filter
Top Products
Yourpressure washer requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3t36.
IMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
Open carton and slice two corners opposite guide
handle from top to bottom so the panel can be
folded down flat.
Remove fillers, accessories and parts bag shipped
with your pressure washer.
Remove the pressure washer out the open end of
the carton.
Check carton for additional loose parts.
CARTON CONTENTS
Check all contents, If any parts are missing or damaged,
cell the pressure washer helpline at t-800-222-3136,
The main unit
High pressure hose
Spray gun
Nozzle extension with adjustable nozzle
Turbo wand
Accessory holder
Engine oil
Parts bag (which includes items listed below)
Owner's manual
Registration card
Become familiar with each piece before assembling
the pressure washer. Compare contents against the
view on page 5. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222_3136.
ASSEMBLING YOUR PRESSURE
WASHER
Your Craftsman pressure washer was mostly
assembled at the factory, However, you will need to
perform these tasks before you can operate your
pressure washer:
1. Add oil to engine crankcase.
2. Add fuel to fuel tank.
3. Connect high pressure hose to spray gun and
pump.
4. Connect water supply to pump.
Attach Accessory Holder
1, Place accessory holderontotop of handle,
2. Place nozzle extension, turbowand and spray gun
into holder.
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure,
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight, DO NOT use special additives,
1. Choose a viscosity according to the following table.
STARTING TE_ FERATURE RANGE AINTICIPATEE)BEFORE NEXT OIL CHANGE
* The use of multi-viscesiN oils (5W-30, 10W-30, etc.)
in temperatures above 40=F (4=C) will result in higher
than normal oil consumption. When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures below 40=F
(_=C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
2. Place pressure washer on a level surface.
3. Clean area around oil fill.
4. Remove oil fill cap and dipstick.
5. Wipe dipstick clean, insert it intooil fill hole and
tighten securely, remove dipsticK. Add
recommended oil up to "Fall" mark on dipstick.
6