Filter
Top Products
YourCraftsmangeneratorrequiressomeassembly
andis readyfor useafterit hasbeenproperlyserviced
withtherecommendedoilandfuel.
Ifyou haveanyproblemswiththeassemblyof
yourgenerator,pleasecallthe generatorhelpline
at 1-800-222-3136.
IMPORTANT:Anyattemptto runtheenginebeforeit
hasbeenservicedwiththerecommendedoilwillresult
inanenginefailure.
TO REMOVE THE GENERATOR
FROM CARTON
• Set the carton on a rigid flat surface with "THIS
SIDE UP" arrows pointing upward. See "Cold
Weather Operation" on page 9 before cutting
carton.
• Carefully open the top flaps of the shipping carton.
• Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
• Remove all packing material, carton filters, etc.
• Remove the generator from the shipping carton.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the generator helpline at
1-800-222-3136.
The carton contains:
• The main unit
• Battery charge cables
• Spark plug
• Air filter
• Spark plug wrench
• Owner's manual
• Engine oil
• Wheel kit
ASSEMBLING THE WHEEL KIT
The wheel kit is designed to improve the portability of
your generator.
To install the wheel kit, you need the following tools:
• 15/16" box, open end or socket wrench.
• (2) 13mm box, open end or socket wrenches.
Install wheel kit as follows (refer to illustration below):
• Place the bottom of the generator cradle on a flat,
even surface.
• Place axle stud through metal tab on cradle frame.
• Use a 15/16 inch wrench to secure the axle stud to
frame with 5/8-18 jam nut.
• Install the other axle stud in the same manner.
NOTE: Be sure to install the wheel with raised hub
inboard.
• Tip unit and install wheel.
• Retain wheel on axle stud with retaining pin and
flat washer. Install other wheel on remaining axle
shaft in the same manner.
• Remove the two front nuts and lock washers from
vibration mounting with 13mm wrench. Use these
nuts to retain the mounting leg.
Wheel Kit
NOTE: Fold-down handle not shown
z_
Axle Stud
%..
>
Mounting Leg
Use existing fasteners
to secure mounting leg'
Flat Washer
;/
5/8-18 Lock
Jam Nut
/ /
/
10" Diameter Wheel /
Retaining Pin
4