Craftsman 536.88112 Snow Blower User Manual


 
How To Install
The Speed Control Rod
1. Put the speed select lever into the
sixth gear position.
2. Attach the speed control rod (end
with 90 ° bend) to the speed select
bracket with washer and cotter
pin. See Figure 9.
3. Put the speed select lever into the
first gear position.
,
Attach the ball joint, located on the
bottom end of the speed control
rod, to the shift yoke assembly.
See Figure 10. The fasteners are
attached to the ball joint at the
factory.
The length ot the ball joint and speed
control rod have been pre-adjusted at
the factory. _f an adjustment is required,
loosen the nut. Remove the fasteners
to disconnect the ball joint from the
shift yoke assembly. To lengthen or
shorten the speed control rod, turn the
adapter to obtain the correct length.
5. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
_Speed Select
Speed ][ Lever
Select
Bracket
Washer 3/8"
Speed
Control
Rod
!
Pin
Figure 9
Speed Control Rod
Adapter _
Joint Fasteners
Figure 10
How To Assemble
The Chute Deflector
1. Remove the carriage bolt. See
Figure 11.
2. Raise the chute deflector into op-
erating position,
3. Fasten chute deflector to flange
with carriage bolt. Make sure to
install with head of the carriage
bolt on the inside of the flange.
4. Fasten with washer and Iocknut.
5. Tighten Iocknut securely.
NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN.
6. Cut tie strap on chute deflector.
Chute
Deft
Carriage
Bolt
F-001129J
Operating Po_
Flange W;
_Lsher Nut
10
Tie Strap
Figure 11