Filter
Top Products
TROUBLE SHOOTING CHART
TROUBLE CAUSE
Engine difficult to start Stale fuel
or
Engine runs erratically
or
Engine will not run at full
speed
Clogged fuel filter
Dirt in fuel tank or out of fuel
Carburetor out of adjustment
Fouled spark plug
Dirty air filter
Engine smokes Plugged air filter
excessively
Clean debris from blade.
Cutting blade will not
rotate
Debris interfering with blade
Loose blade
Defective V-belt
Defective quill bearings
Damage or worn blade
CORRECTION
Drain fuel tank. Fill with fresh
fuel.
Replace fuel filter
Clean fuei tank.
Take unit to a Sears Service
Center.
Clean and set spark plug
gap.
Replace air filter.
Replace air filter.
Blade will not cut properly
Excessive vibration Loose parts Stop engine immediately.
Tighten all fasteners. If
vibration continues, take the
unit to a Sears Service
Center.
Engine does not shut off Loose handle Tighten handle knobs.
when engine control lever
is released
Tighten blade nut.
Replace V-belt.
Replace the quill assembly.
Reverse the blade or replace
the blade.
F_001101M 20