Filter
Top Products
• Watch out for branches immediately
behind the branch being pruned. If
the chain hits the rear branch, dam-
age to the unit may occur.
• Be alert for springback. Watch out
for branches that are bent or under
pressure. Avoid being struck by the
branch or the pruner when the ten-
sion in the wood fibers is released.
• Keep a clear work area. Frequently
clear branches out of the way to
avoid tripping over them.
• Long branches should be removed
in several pieces.
PRUNING TECHNIQUE
When ready to cut, accelerate to full
throttle and apply a light cutting pres-
sure. DO NOT use back and forth
sawing action.
1. Make the first cut 6 inches (15 cm)
from the tree trunk on the bottom
of the limb. Use top of guide bar
to make this cut. Cut 1/3 through
the diameter of the limb.
NOTE: When making the second and
third cuts, rest the foot of the pruner
against the tree limb that is being cut
to prevent whipping of the branch.
i Second cut
Third cut
Coil
2. Next, move 2 - 4 inches (5 - 10
cm) farther out on the limb and
make a second cut all the way
through the limb.
3. Then, make a final cut leaving a 1
- 2 inch (2.5 - 5 cm) collar from
the trunk of the tree to avoid dam-
age to the tree.
First cut
Pruning technique
_WARNING: Always stop unit
and disconnect spark plug wire (or
disconnect powerhead from power
source) before performing mainte-
nance.
CHECK FOR DAMAGED OR
WORN PARTS
Contact a Sears Service Center for
replacement of damaged or worn
parts.
• Oil tank - Discontinue use of pruner
attachment if oil tank shows signs of
damage or leaks.
CHECK FOR LOOSE
FASTENERS AND PARTS
• Bar clamp nut
• Fasteners
INSPECT AND CLEAN UNIT AND
DECALS
• After each use, inspect complete
unit for loose or damaged parts.
Clean the unit and decals using a
damp cloth with a mild detergent.
• Wipe off unit with a clean dry cloth.
CHECK CHAIN TENSION
,_ WARNING: Wear protective
gloves when handling chain. The
chain is sharp and can cut you even
when it is not moving. Make chain ad-
justments with lower end supported.
Chain tension is very important. Chains
stretch during use. This isespecially
true during the first few times you use
your pruner. Always check chain ten-
sion each time you use and refuel your
unit.
11