Craftsman 486.252444 Tiller User Manual


  Open as PDF
of 20
 
4
TO REMOVE UNIT FROM
CARTON
• Cutfromtoptobottomallfourcornersofthecarton
andlaypanelsat.(SeeFig.1)
• Removethelagscrewthatholdstheoatinghitchto
thepackingskid.
• Disassembleanddiscardcarton'swoodtopandside
supports.
• Removefourhexbolt,hexnutsandatwasherfrom
theholddownbracketsattherearofthecarton.
• RemoveandsavethetwoFlatWashersandCotter
Pinsfromtherearaxle.Reusewhenattachinggauge
wheels.
• Discardallotherpackinghardwareandholddown
brackets.
TO INSTALL THE TILLER
GAUGE WHEELS
• AssembleGaugeWheelsontotheRearAxlewiththe
extendedendofHubfacinginward.Securewiththe
FlatWashersandCotterPinswhichyouremovedfrom
theaxleduringunpacking.(Seeg.2.)
• Righthand(RH)andlefthand(LH)aredetermined
fromthedriverspositionwhileseatedonthetractor.
• WerecommendthatyouremovetheMowerDeck
beforeusingtheTiller.RefertoyourTractorOwner's
Manual.
3/8" NYLOCK
NUT
TO INSTALL THE TILLER TINE
ASSEMBLIES
• Attachtheoatinghitchtothetractor'sdrawbar.
(RefertoOperatingInstructionsonpage7.)
• Removethepreassembled3/8"x2"hexboltand3/8"
nylocknutfromtheL.H.TineAssembly.Slidethetine
assemblyontotheTransmissionAxleontheleftside
ofthetillerandsecurewiththehexboltandnylock
nut.(Seeg.3.)RepeatfortheR.H.side.
FIG. 1
FIG. 2
FIG. 3
ASSEMBLY
 previous next