Filter
Top Products
• Assemblea shorttarpstrapto reardoorusingone
1/4"x 1-1/4"hexbolt,two1/4"flatwashersandone
1/4"nylocknut.Assemblean"S"hookthroughloose
endofstrap.Seefigure15.Repeatonothersideof
door.
Assembledoortorearofcartbyrestingbottomof
doorondoorsupportsandpushingtopofdoorin
againstcrossbrace.Securetopofdoorusingdoor
latchesoneachside.Seefigure15.
Hookboththetarpstrapsontothe1/4"x 1"hexbolts
inthesidesofthecart.Seefigure15.
DOOR LATCH
1/4" x 1-1/4" HEX BOLT
1/4" FLAT WASHER
STRAP (SHORT)
1/4" FLAT
WASHER
1/4" NYLOCK NUT
FIGURE 15
DOOR
SUPPORTS
1/4" x 1"
HEX BOLT
Attach the engine/impeller housing assembly to the
upper holes in the angles welded to the tongue. Use
four 5/16" x 3/4" hex bolts and 5/16" nylock nuts.
Tighten. See figure 16.
Assemble the elbow to the impeller housing using four
5/16" x 3/4" thread forming hex bolts and four nylon
washers. Push while turning to help start the bolts into
the unthreaded holes. Tighten. See figure 17.
To center the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/4 turn each, the four
bolts that you assembled in figure 17.
c. Push against the elbow to center it with the sides
of the opening.
d. Retighten the four bolts that you loosened.
Pull the vinyl boot onto the end of the elbow.
Center elbow between
sides of opening
NYLON
WASHER
5/16" x 3/4"
HEX BOLT
(Thread Forming) __
Loosen (4) bolts
1/4 turn each
FIGURE 17
5/16"
NYLOCK
NUT
i
I
_ 5/16" x 3/4"
_ HEX BOLT
/
WELDED
ANGLES
FRON
_TONGUE
FIGURE 16
12 Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE