Craftsman 486.24717 Chipper User Manual


 
Flipthecartoversothatit restsonitswheels. ASSEMBLING VAC PARTS
Assemble the front tongue on top of the rear tongue
using three 3/8" x 3" hex bolts and 3/8" nylock nuts.
See figure 8.
HINT: For easier assembly, support the rear tongue with
a block of wood.
%
%
3/8" x 3"
HEX BOLT
TONGUE
(FRONT)
/
318"NYLOCK NUT
\
BLOCK
FIGURE 8
Assemble the hitch bracket to the front tongue using
two 3/8" x 1-1/4" hex bolts and 3/8" nylock nuts.
Tighten. See figure 9.
Secure the hitch pin to the hitch bracket and tongue
with the hair cotter pin. See figure 9.
r
318"NYLOCK NUT
TONGUE
HAIR
COTTER
PIN
FIGURE 9
Release the latch lock lever and tilt the cart bed back.
See figure 10.
Assemble the front panel to the cart bed, sliding
the bottom lip of the panel in between the cart bed
and the latch stand bracket. Fasten the panel to the
bottom and sides of the cart bed using six 1/4" x 5/8"
hex bolts and 1/4" nylock nuts. Tighten. See figure 10.
Tighten the two bolts that you assembled to the latch
stand bracket in figure 5.
FRONT
PANEL
1/4" x 5/8"
HEX BOLT
\
\
114"NYLOCK NUT
\\
\
1/4" x 5/8"
HEX BOLT
LATCH
STAND
BRACKET
FIGURE 10
10 Cal11-866-576-8388formissingpartsorassemblyhelp
DO NOT RETURN TO STORE