Filter
Top Products
iNSTRUCTiONS FOR SINGLE SUSPENSION BRACKET TRACTORS
STEP 1 : (SEE FIGURE 2)
Open parts bag labelled "A" and verify that all parts
are present.
NOTE: Place cardboard or a mat on work surface to prevent
scratching of parts removed from carton and tractor.
HARDWARE SHOWN FULL SiZE
EXCEPT WHERE NOTED
(not full size)
PARTS BAG "A"
..... C
FIGURE 2
Ref. Part Qty. Description
A 43350 4 Carriage Bolt, 3/8-16 x 1"
B 44072 4 Whizlock Nut, 3/8"
C R19171616 4 Washer, 1/2"x1"
D 44742 2 Plug
65932 1 Bumper
STEP 2: (SEE FIGURE 3)
Remove tractor hood. (Refer to tractor manual.)
Remove the browning shield as shown.
REMOVE
FRONT SCREWS
\
REMOVE
BROWNING SHIELD
FIGURE 3
STEP 3: (SEE FIGURE 4)
Place plug on a work bench or solid table and push
end of bumper down onto plug. Repeat for second
plug.
BUMPER
-.._
PUSH DOWN
WmTH EVEN
PRESSURE
WORK BENCH SHORT STEP
OR SOLID TABLE _ _,,_...----_ PLUG
_-_> F,GURE 4
STEP 4: (SEE FIGURE 5)
Insert a carriage bolt into the second mounting hole
from the front of the tractor frame and fully tighten a
whizlock nut onto the bolt. Repeat on other side of
tractor.
CARRIAGE BO_
AND WASHER
Catt1-866-576-8388formissingpartsorassemblyhelp
DO NOT RETURN TO STORE
WHIZLOCK
NUT
FIGURE 5
3