Filter
Top Products
5
FIGURE 3
• Identify the short end of the shaft. Assemble a 1" long
spacer (S), a single spool assembly, a 1.33" long
spacer (T), a double spool assembly, another 1.33"
long spacer (T) and a 3/4" at washer (N) onto the
short end of the shaft. See gure 3.
SINGLE SPOOL
ASSEMBLY
DOUBLE SPOOL
ASSEMBLY
1.33" LONG
SPACER (T)
1" LONG
SPACER (S)
1.33" LONG
SPACER (T)
3/4" FLAT
WASHER (N)
SHORT END
OF SHAFT
FIGURE 4 REAR VIEW
• Assemble the middle brace onto the long end of
the shaft with the bent end of the brace facing the lift
lever. Next assemble a 3.70" long spacer (R), a single
spool assembly, a 1.33" long spacer (T), a double
spool assembly, a 1.33" long spacer (T) and a 3/4" at
washer (N) onto the long end of the shaft. See gure
4.
1.33" LONG
SPACER (T)
1.33" LONG
SPACER (T)
MIDDLE
BRACE
3.70" LONG
SPACER (R)
3/4" FLAT
WASHER (N)
SINGLE SPOOL
ASSEMBLY
DOUBLE SPOOL
ASSEMBLY
LIFT
LEVER
FIGURE 5
• Assemble the end plates to the ends of the tray using
four 5/16" x 3/4" hex bolts (E) and four 5/16" nylock
nuts (J) for each end plate. Do not tighten until nal
step. See gure 5.
5/16" x 3/4"
HEX BOLT (E)
5/16" NYLOCK
NUT (J)
FIGURE 6
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK
NUT (I)
1/4" NYLOCK
NUT (K)
1/4" x 3/4"
HEX BOLT (O)
STOP
BRACKET (U)
RIGHT SIDE
LEFT SIDE
• Assemble the tongue to the tray using four 3/8" x 1"
hex bolts (D) and 3/8" nylock nuts (I) as shown in
gure 6. Tighten.
• Assemble the two stop brackets (U) to the tongue
using four 1/4" x 3/4" hex bolts (O) and 1/4" nylock
nuts (K). Position the bottom bracket as far to the right
side as possible. Position the top bracket as far to the
left side as possible. Tighten. See gure 6.