Filter
Top Products
5
• Insert the upright tubes onto the right and left base
tubes, turning the upright tubes so that the small
hole shown in figure 4 faces inward. Fasten using
two 1/4” x 1-1/4” and two 1/4” nylock nuts. See
figure 4.
FIGURE 4
• Attach top tubes to the upright tubes, but do not
install mounting bolts at this time. See figure 5.
FIGURE 5
• Unfold sun shade and locate the nylon loops found
on the mesh portion of the sun shade. The mesh is
located at the rear. See figure 6.
• Hold the sun shade in front of the top tubes and
slip the nylon loops onto the ends of the top tubes.
Slide the sun shade along the top tubes, inserting
the ends of the tubes into the stitched sleeves on
each side of the sun shade. Continue until the
ends of the tubes extend out in front of the sun
shade. See figures 6 and 7.
FIGURE 6
FIGURE 7
TOP TUBES
UPRIGHT
TUBES
NYLON LOOP
SLEEVE
SUN SHADE
SMALL
HOLE
UPRIGHT TUBE
1/4" NYLOCK
NUT
1/4" x 1-1/4"
HEX BOLT