Filter
Top Products
6
• Position the height adjustment handle side to side so
that the tooth lock washer can fi t between the handle
and the height adjustment strap.
Tighten
the nuts
securing the height adjustment handle. See fi gure 8.
•
Insert the 5/16" x 1" carriage bolt through the height
adjustment handle. Assemble onto the bolt, in order,
the 5/16" tooth-lock washer, the height adjustment
strap, a 5/16" fl at washer and the plastic knob. See
fi gure 8.
FIGURE 8
ASSEMBLY OF HOPPER BAG
•
Hold the (LH) upper hopper tube so that the hole
for the brace rod faces down. Insert the (LH) upper
hopper tube down through the stitched fl ap on the
left side of the hopper bag. Repeat for the right hand
upper hopper tube. See fi gure 7.
FIGURE 9
(LH) UPPER
HOPPER
TUBE
HOPPER
BAG
BOTTOM
BRACE ROD HOLE
MUST FACE DOWN
5/16" x 1"
CARRIAGE BOLT
TOOTH LOCK
WASHER
PLASTIC
KNOB
5/16" FLAT
WASHER
• Assemble the height adjustment handle to the
height adjustment tube as shown in fi gure six. Use
two curved head bolts, bowed washers, 5/16" lock
washers and 5/16" hex nuts.
Do not tighten yet.
See
fi gure 6.
•
Assemble the grip onto the height adjustment handle.
See fi gure 6.
• Insert a 5/16" x 3/4" hex bolt through the angle
bracket. Assemble onto the bolt (in sequence) the
spacer bushing, the height adjustment strap, a 5/16"
fl at washer and a 5/16" hex lock nut.
Tighten.
See
fi gure 7.
FIGURE 6
FIGURE 7
CURVED
HEAD BOLT
5/16" HEX NUT
BOWED
WASHER
5/16" LOCK
WASHER
HEIGHT
ADJUSTMENT
HANDLE
GRIP
5/16" HEX
LOCK NUT
5/16" FLAT
WASHER
HEIGHT
ADJUSTMENT
STRAP
5/16" x 3/4"
HEX BOLT
SPACER
BUSHING