Filter
Top Products
4
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
(1) Phillips Screwdriver
(1) Adjustable Wrench
(1) 7/16" Open End or Box Wrench
1. Assemble the two Handle Leg Stand Tubes to the
Sweeper Housing, using two hex bolts 1/4-20 x 1-
1/4" long, fl at washers and 1/4-20 hex lock nuts, per
handle. See fi gure 1. Only hand tighten at this time.
2. Assemble the Upper Handle Tube over the Handle
Leg Stand Tubes. See fi gure 2. Align holes in handle
and assemble the Bag Rod Clips to the handle as
shown and fasten with curved head bolts and hex lock
nuts.
FIGURE 1
FIGURE
2
3. Now tighten the four bolts from step 1.
4. Assemble a bag rod clip to the inside of each lower
handle tube using a curved head bolt secured down
against the clip using a 1/4" lock nut. The open end
of the clips should face towards the sweeper housing.
See fi gure 3.
5. Slide the long bag rod (28-1/2" long) through the
stiched bag fl ap on the top of the hopper bag as
shown in fi gure 4.
6. Slide the short bag rod (25-1/2" long) through the
stiched bag fl ap on the bottom of the hopper bag as
shown in fi gure 4.
FIGURE
3
FIGURE
4