Craftsman 358.799343 Blower User Manual


 
all.WARNING: Perform the follow-
ing steps after each use:
Stop unit and disconnect from the
power source.
Store the unit in a stable location.
Store unit with all guards in place.
Position unit so that any sharp object
cannot accidentally cause injury.
Store unit well out of the reach of chil-
dren.
Prepare unit for storage at the end of
the season or if it will not be used for
30 days or more.
BLOWER STORAGE
Disconnect from tile power source.
Clean the entire unit.
Inspect the blower and all tubes.
Clean air vents and air inlet of debris.
Store your unit and extension cord in a
well ventilated area and covered, if
possible, to prevent dust and dirt accu-
mulation. Do not cover with plastic.
Plastic cannot breathe and may cause
condensation and eventual rust or cor-
rosion.
Check entire unit for loose screws. Re-
place any damaged, worn, or broken
parts.
TROUBLESHOOTING TABLE
WARNING: Always stop unit and disconnect from the power source before
performing all of the recommended remedies below except remedies that re-
quire the unit to be operating.
SYMPTOM CAUSE REMEDY
Unit fails to 1. Switch in the OFF position. 1. Move switch to the ON position.
operate. 2. Extension cord disconnected. 2. Reconnect extension cord.
3. Circuit breaker tripped, or 3. Reset circuit breaker or
fuse blown, fuse.
4. Mechanical failure. 4. Contact Sears Service (see back
cover).
Unit 1. Mechanical failure. 1. Contact Sears Service (see back
vibrates cover).
abnormally.
Impeller will 1. Debris in air intake area. 1. Clean unit. Remove any debris.
not turn 2. Mechanical failure. 2. Contact Sears Service (see back
freely, cover).