Filter
Top Products
2. Push the small end of the elbow
tube through the small opening in
the bag.
Elbow
Tube
Small
Opening
Zipper
Opening Rib
NOTE: Make sure edge of the smaIt
opening is flush against the flared area
of the elbow tube, and the rib on the
eIbow tube is on the bottom.
3. Close the zipper on the bag. Make
sure the zipper is closed complete-
ly.
4. Remove blower tube from engine.
i]_ Rib
Groove
5. _vtube into the blow-
er outlet. Make sure elbow tube is
aligned with the bIower outlet
groove.
6. Turn clamp knob clockwise to tight-
en.
7. Secure the ends of the shoulder
strap by routing the strap through
the buckle as shown.
2. insert a screwdriver into the latch
area on the vacuum inlet cover.
Latch _ Blower
A_ Outlet
Latch Area
Vacuum
inlet Cover
3. Gently titt the handle of the screw-
driver toward the back of the unit
while pulling up on the vacuum in-
let cover with your other hand.
4. Hold the vacuum inlet cover open
until upper vacuum tube is
installed.
Vacuum Inlet
Retaining Post
Vacuum
Inlet
Oover--_
5. Place the hooks on the vacuum
tube on the retaining posts; pivot
tube into position. Secure vacuum
tube by turning the knob clockwise
until tight.
VACUUM TUBE ASSEMBLY
1. Align the lower vacuum tube as
shown. Push lower vacuum tube
into upper vacuum tube.
Upper
Vacuum Tube
Lower
Vacuum Tube
Hooks
6. When converting back to the blow-
er feature, make sure latch on the
vacuum inlet cover is securely fas-
tened.
-5-