Filter
Top Products
STARTINGAFLOODEDENGINE
Floodedenginescanbestartedby
pullingthestarterhandlerepeatedly
whilesqueezingthrottletriggeruntil
engine starts and runs. This could re-
quire pulling the starter handle many
times, depending on how badly the
unit is flooded.
if the unit still doesn't start, refer to the
TROUBLESHOOTING TABLE or call
1-800-235-5878.
OPERATING INSTRUCTIONS
To maximize operating efficiency, do
not run the engine for longer than 1
minute at a time at full throttle.
OPERATING POSITION
ALWAYS WEAR: _.,__
Long pants__
Heovyshoe2
Out from your right to y left,
Eye protection
z_
dt_WARNING: Always wear eye
protection. Never lean over the trimmer
head. Rocks or debris can ricochet or
be thrown into eyes and face and
cause blindness or other serious injury.
When operating unit, stand as shown
and check for the following:
• Wear eye protection and heavy
clothing.
• Hold trigger handle with right hand
and assist handle with left hand.
• Hold unit so that engine is below
waist level.
• Cut only from your right to your left to
ensure debris is thrown away from
you. Without bending over, keep line
near and parallel to the ground and
not crowded into material being cut.
Do not run the engine at a higher
speed than necessary. The cutting
line will cut efficiently when the engine
is run at less than full throttle. At lower
speeds, there is less engine noise and
vibration. The cutting line will last
longer and will be less likely to "weld"
onto the spool.
Always release the throttle trigger and
allow the engine to return to idle
speed when not cutting.
To stop engine:
• Release the throttle trigger.
• Push and hold the STOP switch in the
STOP position until the engine stops.
TRIMMER LINE ADVANCE
The cutting head advances line au-
tomatically. Do not tap head on the
ground to advance line. This may
break parts and cause cutting head to
malfunction. Upon unit start up, the line
will advance automatically to the correct
cutting path length. Always keep the
shield in place when the tool is being
operated.
_L, WARNING: Use only 0.080
inch (2 ram) diameter round line.
Other sizes and shapes of line will not
advance properly and will result in im-
proper cutting head function or can
cause serious injury. Do not use other
materials such as wire, string, rope,
etc. Wire can break off during cutting
and become a dangerous missile that
can cause serious injury.
CUTTING METHODS
,_WARNING: Use minimum
speed and do not crowd the line when
cutting around hard objects (rock,
gravel, fence posts, etc.), which can
damage the trimmer head, become
entangled in the line, or be thrown
causing a serious hazard.
• The tip of the line does the cutting.
You will achieve the best perform-
ance and minimum line wear by not
crowding the line into the cutting
area. The right and wrong ways are
shown below.
Tip of the Line Line Crowded Into
Does The Cutting Work Area
Right Wrong
• The line will easily remove grass
and weeds from around walls,
fences, trees and flower beds, but it
also can cut the tender bark of trees
or shrubs and scar fences. To help
avoid damage especially to delicate
vegetation or trees with tender bark,
shorten line to 4-5 inches (10-13
cm) and use at less than full throttle.