Filter
Top Products
MENTSsection).Neverusewire,
rope,string,etc.
• Usespecifiedtrimmerspool.Make
surespoolisproperlyinstalledand
allpartsaresecurelyfastened.
• UseonlyCraftsman(_replacement
partsandaccessoriesasrecom-
mended.
CUTTINGSAFETY
_.WARNING: Inspect area to be
cut. Remove objects (rocks, broken
glass, nails, wire, string, etc.) which
can be thrown or become entangled in
cutting head.
• Do not overreach or stand on unsta-
ble support. Keep firm footing and
balance.
• Keep the cutting head below waist
level. Do not raise handles above
your waist. Cutting head can come
dangerously close to your body.
• Keep away from cutting head and
spinning line.
• Use unit properly. Use only for trim-
ming, scalping, and mowing. Do
not force unit. It will do the job better
and with less risk of injury at the rate
for which it was designed.
• Use only in daylight or in good artifi-
cial light.
MAINTENANCE SAFETY
_iWARNING: Disconnect unit
from the power supply before perform-
ing maintenance, or when changing
trimmer line.
• Maintain unit according to recom-
mended procedures. Keep cutting
line at proper length. Follow instruc-
tions for changing trimmer line.
• Have all service and maintenance
not explained in this manual per-
formed by a Sears Service Center to
avoid creating a hazard.
• Never douse or squirt the unit with
water or any other liquid. Clean unit
and labels with a damp sponge.
Keep handles dry, clean, and free
from oil and grease.
• Keep the air vents clean and free of
debris to avoid overheating the mo-
tor= Clean after each use.
TRANSPORTING AND STORAGE
• Stop the unit and disconnect the
power source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter
blade (on underside of shield) can-
not cause injury.
• Store unit indoors in a high, dry
place out of the reach of children.
Store unit unplugged.
• Do not hang unit so that the trigger
switch is depressed.
DOUBLE INSULATION
CONSTRUCTION
This unit is double insulated to help pro-
tect against electric shock. Double in-
sulation construction consists of two
separate "layers" of electrical insulation
instead of grounding.
Tools built with this insulation system
are not intended to be grounded. No
grounding means is provided on this
unit, nor should a means of grounding
be added to this unit. As a result, the ex-
tension cord used with your unit can be
plugged into any standard 120 volt elec-
trical outlet.
Safety precautions must be observed
when operating any electrical tool. The
double insulation system only provides
added protection against injury result-
ing from an internal electrical insulation
failure.
,_WARNING: All electrical repairs
to this unit, including housing, switch,
motor, locking sleeve assembly, wires,
etc., must be diagnosed and repaired
by qualified service personnel. Re-
placement parts for a double insulated
appliance must be recommended by
the manufacturer. A double insulated
appliance is marked with the words
"double insulation" or "double insu-
lated". The symbol (square within a
square) [] may also be marked on
the appliance. Failure to have the unit
repaired by qualified service person-
nel can cause the double insulation
construction to become ineffective and
result in serious injury.
SAVE THESE INSTRUCTIONS