Filter
Top Products
IdleSpeed-T
Allowenginetoidle.Ifthechainmoves,
idleistoofast.Iftheenginestalls,idleis
tooslow.Adjustspeeduntilengineruns
withoutchainmovement(idletoofast)or
stalling(idletooslow).Theidlespeed
screwis tocated in the area above the
primer bulb and is labeled T.
• Turn idle screw (T) clockwise to in-
crease engine speed.
• Turn idle screw (T) counterclockwise
to decrease engine speed.
tf you require farther assistance or are
unsure about performing this procedure,
contact your Sears Service Center or
call our customer assistance help line at
1-800-235-5878.
dlllWARNING: Perform the follow-
ing steps after each use:
• Allow the engine to coot, and secure
the unit before storing or transporting.
• Store chain saw and fuel in a well
ventilated area where fuel vapors
cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces, etc.
• Store chain saw with all guards in
place and position chain saw so that
any sharp object cannot accidentally
cause injury.
• Store chain saw well out of the reach
of children.
SEASONAL STORAGE
Prepare your unit for storage at the
end of the season or ff it wilt not be
used for 30 days or more.
If your chain saw is to be stored for a
period of time:
• Clean saw thoroughly before storage.
• Store in a clean dry area.
• Lightly oil external metal surfaces
and guide bar.
• Oil the chain and wrap it in heavy pa-
per or cloth.
FUEL SYSTEM
Empty the fuel system before storage
for 30 days or longer. Drain the gas
tank, start the engine and let it run until
the fuel lines and carburetor are empty.
Use fresh fuel next season.
Under FUELING ENGINE in the OPERA-
TION section of this manual, see mes-
sage labeled IMPORTANT regarding
the use of gasohot in your chain saw.
Fuel stabilizer is an acceptabIe alter-
native in minimizing the formation of
fuel gum deposits during storage. Add
stabilizer to the gasoline in the fueI
tank or fuel storage container.
Follow the mix instructions found on
stabilizer containers. Run engine at
least 3 minutes after adding stabilizer.
Craftsman 40:1,2-cycle engine oil (air
cooled) is blended with fuel stabilizer, tf
you do not use this oil, you can add a
fuel stabilizer to your fuel tank.
ENGINE
• Remove spark pIug and pour 1 taa-
spoon of 40:1,2-cycte engine oil (air
cooled) through the spark plug open-
ing. Slowly pull the starter rope 8 to
10 times to distribute oil.
• Replace spark plug with new one of
recommended type and heat range.
• Clean air filter.
• Check entire unit for loose screws,
nuts, and bolts. Replace any dam-
aged, broken, or worn parts.
• At the beginning of the next season,
use only fresh fuel having the proper
gasoline to oil ratio.
OTHER
• Do not store gasoline from one sea-
son to another.
• Replace your gasoline can if it starts
to rust.
20