Filter
Top Products
8
ASSEMBLY INSTRUCTIONS
NOTE: Reference to right or left hand side of the
cultivator is observed from the operating
position.
Removing Unit From Carton
1. Remove staples, break glue on top flaps, or cut tape
at carton end and peel along top flap to open carton.
2. Remove all loose parts that may be included with
unit.
3. Cut along corners, lay carton down flat, remove and
set safely aside any packing material and/or loose
cardboard.
4. Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton
• Operator’s Manual
Tools Needed for Assembly
• None
ASSEMBLING CULTIVATOR
Handle Set-Up
1. Loosen each hand knob found on the inside of the
upper handle (Fig. 1).
2. Gently lift and pivot the upper handle into the
operating position (Fig. 2).
3. Secure the upper handle and lower handle by
tightening the hand knobs (Fig. 2). Each carriage
bolt must be seated properly into the square hole
found in the plastic connector.
1
2
Fig. 1
Fig. 2
To prevent serious
personal injury, do
not connect electric
extension cord to unit until fully completing
cultivator assembly
WARNING: