Filter
Top Products
2. Carefully remove each tine assembly from the tine
shafts.
3. Wipe each tine shaft clean with a damp cloth and
apply a light coat of oil (i.e. 3-N-One) or silicon-based
lubricant to each shaft. Do NOT use WD-40.
4. Rinse each tine assembly with water and thoroughly
dry each it before placing on tine shaft.
5. Re-insert each click pin to secure the tine assemblies
in place.
Tips for Replacing Tines
• Each tine shaft holds one tine assembly stamped "A"
and one tine assembly stamped "B".
• The bell sides of both tine assemblies (on each shaft)
should face each other (Fig. 9).
• The hub of each tine assembly (Fig. 9) should face
outward (away from the cultivator's gearbox).
12
MAINTENANCE AND REPAIR INSTRUCTIONS
Fig. 9
Removing and Replacing Tines
Cultivator tines are subject to wear and should be
replaced if any signs of damage are present.
Tines should also be removed and cleaned after each
use.
To replace the cultivator's tines:
1. Remove the click pin found at the end of each tine
shaft.
NOTE: Each tine assembly is stamped either "A" or "B"
(Fig. 9). Note each tine's location on the shaft for
easier reassembly
To prevent serious
injury, never perform
maintenance or
repairs with unit running. Always service and
repair a cool unit.
WARNING:
Avoid accidental
starting. Stop motor
and disconnect
extension cord prior to performing any
maintenance or repairs.
WARNING:
Hubs
Click
Pin
Do not wash
cultivator with a
hose. Avoid getting
water on motor and electrical connections.
WARNING:
Bell Side of Tines
Cultivator tines are
sharp. Always wear
leather gloves to
protect your hands when handling tines.
WARNING:
Gearbox