Filter
Top Products
Attaching the Nozzle
(See Figure3.)
• Removethe three plasticwing nutsfrom the
frontof the chipper-shreddervacuum.
• Place the nozzle overthe three weld studs.
• Securewith the plasticwing nutsjust removed.
Nozzle
%
\
Tighten
Securely
Figure 3
NOTE: Themetal tab inthe nozzle mustdepress the
safety switchon the frontofthe chipper-shredder
vacuum or theengine willnot start. See Figure 4.
Plastic
Wing Nuts
Nozzle
Metal
Tab
Figure 4
Attaching the Chipper Chute
Loosen,but do NOT remove, the two hex bolts.
flat washers,and flange nutswhichare secured
to the support bracket. See Figure 5.
Chipper
Chute"_
Hex Bolts
Washers
Flange=
Nuts
Bracket
Figure 5
• Remove thetwo flange nuts, hexboltsand
saddlewashers whichsecure the rightside of
the upper handleto the rightside ofthe lower
handle. See Figure6.
• Next, remove thethree hex nutsand bell
washers from theweld studsfound beside the
openingon therightside ofthechipper-shredder
vacuum. See Figure6.
6