Filter
Top Products
17
16
INSTALLING THE BATTERY PACK (Fig. 4)
INSTALLING THE SAFETY GUARD (Figs. 5 and 5a)
THE EDGE GUIDE (Fig. 6)
1. Place the battery pack into the rear handle of the trimmer, aligning the raised rib on
battery pack with grooves on trimmer.
2. Make sure the latches on each side of the battery pack “snap” into place, and the
battery pack is secured in the trimmer before beginning operation.
1. Remove the battery pack from the trimmer.
2. Turn the trimmer’s motor housing head over to provide access to underside base of
the head by the cutting line spool.
3. Locate the single screw in the base of the head and remove the screw.
4. Insert the edge of the safety guard into the slot along the back of the trimmer’s head,
carefullly lining the screw hole in the guard up with the screw hole in the trimmer head.
5. Insert screw and securely attach the safety guard (see Figs. 5 and 5a).
Your trimmer comes with an Edge Guide
that is handy for use as a cutting guide.
It can be used to help keep the cutting
line away from items you don’t want cut,
such as flowers, or damaged, such as
fences or screens.
Each end of the wire edge guide is
force-fitted into a hole located on each
side of the trimmer’s head. To use the
edge guide, pull (force) it down into the
guide position as shown in Fig. 6.
CAUTION:
When placing battery pack in the trimmer, be sure raised rib
on battery pack aligns with the indents on trimmer and latches into place
properly. Improper installation of the battery pack can cause damage to
internal components.
!
WARNING:
This Cordless Trimmer is always in operating condition when
the battery pack is installed. Therefore, the Safety On Button should always be
in the released position locking the power off, when the tool is not in use or you
are carrying it at your side. The trigger switch will not turn the trimmer ON until
the Safety On Button is depressed.
!
WARNING:
To avoid injury, ALWAYS remove the battery from the trimmer
BEFORE installing parts, cleaning the trimmer, making any adjustments or
storing the trimmer
!
NOTE: THE SAFETY GUARD MUST BE ATTACHED to the trimmer head before use.
NOTE:
Safety Guard will only fit one way.
Fig. 4
ASSEMBLY & ADJUSTMENTS cont. ASSEMBLY & ADJUSTMENTS cont.
Fig. 5a
Line
Cutter
Fig. 5
Fig. 6