Filter
Top Products
15
14
DESCRIPTION cont.
ASSEMBLY & ADJUSTMENTS
ASSEMBLY & ADJUSTMENTS cont.
The battery pack for this tool has been shipped in a low charge condition to prevent
possible problems. Therefore, you should charge overnight prior to use.
Cutting Path
Speed
Rating
Line Diameter
Line Feed Mechanism
Power Head Tilt
Adjust Height of Shaft
Charging Stand Input
Charge Rate
Charging Stand Number
Battery Pack Number
12 inches
7000 RPM
18.0 Volt
0.065-inch twisted line
Automatic
4 positions
From 16 to 25 inches
120V, 60Hz AC
1 hour
CGT183UA-48 (C1817A005)
CGT183UA-42 (WA 3127)
SPECIFICATIONS
NOTE: Batteries will not reach full charge the first time they are charged. Allow
several cycles (operation followed by recharging) for them to become
fully charged.
NOTE: Within the warranty period, if the charging stand LED lights do not operate
properly, or the charging stand does not charge the battery pack, return the
charging stand and battery pack to your nearest Sears Store or other Craftsman
outlet for free replacement.
NOTE: A hot battery pack only occurs when prolonged continuous use of your
trimmer causes the batteries to become hot. It does not occur with typical use.
Within the warranty period, if the battery pack becomes hot with typical use,
return the charging stand and battery pack to your nearest Sears store or other
Craftsman outlet for free replacement.
CHARGING THE BATTERY PACK (Fig. 3 and 3a)
CHARGING THE BATTERY PACK cont. (Fig. 3 and 3a)
CHARGING A HOT BATTERY PACK
1. Charge battery pack only with the charging stand that was supplied with this trimmer.
2. Make sure power supply to the charging stand is normal household voltage, 120 volts,
60 Hz, AC-only.
3. Connect charging stand to power supply.
4. Place battery pack in charging stand. Align raised rib on battery pack with groove in
charging stand (See Page 15, Fig. 3).
5. Press down on battery pack to be sure contacts on battery pack engage properly with
contacts inside charging stand.
6. The charging stand has two (LED) indicator lights, one green and one red. The green
LED light comes on when the charging stand is plugged into a power outlet. When a
battery pack is put into the charging stand, the green LED light will go off and the
red LED will light, indicating that the battery pack is charging properly (see Fig. 3a).
When the battery pack is fully charged, the red LED will go off and green LED light will
go on to show that battery is fully charged. When the battery pack is removed from the
charging stand, the green LED will stay on until it is unplugged.
7. After normal use, 1 hour of charging time is required to fully recharge battery pack.
If battery pack is completely discharged, 6 hours or longer of charging time is required
to fully recharge battery pack.
8.
The battery pack will become slightly warm to the touch while charging. This is normal
and does not indicate a problem.
9.
Do not place the charging stand in an area of extreme heat or cold. It will work best at
normal room temperature.
10.
When battery pack becomes fully charged, unplug battery charging stand from power
supply and remove the battery pack.
When using your tool continuously, the batteries in your battery pack will become hot.
You should let a hot battery pack cool down for approximately 30 minutes before
attempting to recharge.
Fig. 3 Fig. 3a