Country Home Products 6-TON Log Splitter User Manual


 
CALL TOLL FREE 1-800-DR-OWNER 11
Unpacking and Assembling the DR 6 -TON ELECTRIC WOOD SPLITTER
NOTE: Read this Safety
&
Operating Instructions Manual before using your new DR 6 -TON ELECTRIC
WOOD SPLITTER. The wood splitter shipped from the factory fully assembled with the exception of
the Wheels and the Operation Handle. The following instructions will detail how to unpack and
assemble the machine.
Tools and Parts Supplied:
6mm Hex Wrench
10 - 12mm Wrench
13 - 16mm Wrench
Operating Handle w/
Retaining Bolt and Washer
(2) 6mm Bolts
Extra Hydraulic Seal
(2) Wheels
Additional Tool Required:
Knife
STABILIZE THE SHIPPING CONTAINER ON A FLAT SURFACE BEFORE ATTEMPTING TO UNPACK AND
ASSEMBLE THE MACHINE.
1. With the help of another person (the machine weighs 171
pounds), carefully roll the shipping carton over onto its top.
2. Carefully cut the tape along the bottom seam of the shipping
carton with a knife, open the carton, and remove the Wheel from
the packing; setting it aside (Figure 2).
3. Now, carefully roll the shipping carton back onto its bottom
(Figure 3) and lift the shipping carton off your new DR 6 -TON
ELECTRIC WOOD SPLITTER (Figure 4). The machine should
now be resting on the Front Support Legs and the Rear Support.
4. Remove the second Wheel from the packing (setting it aside)
and any remaining packing materials from the machine. Do not
discard your packaging material until you are fully satisfied with
your new DR 6 -TON ELECTRIC WOOD SPLITTER.
Figure 2
Figure 3 Figure 4
Remove Wheel
Remove Wheel
Bottom of carton
Top of carton
Lift carton up