Classen SC-18/8.0 Brush Cutter User Manual


 
2
SAFETY
HANDLE FUEL SAFELY - AVOID FIRES
Handle gasoline with care; it is highly flammable. Use an
approved gasoline container.
Fill the fuel tank outdoors.
DO NO
T fill tank completely full.
DO NOT smoke while you fill fuel tank.
DO NOT remove gas cap if engine is running.
READ SAFETY SIGNS
Carefully read and follow all caution stickers.
WARNING
ALL GUARDS MUST BE IN PLACE
WHILE MACHINE IS IN OPERATION
OPERATE SAFELY
Carefully read this manual and operate sod cutter correctly.
PROTECT CHILDREN
Keep children and pets out of the area where you are cutting
sod.
AVOID TIPPING
Make sure you do not get too close to sharp drop-offs to avoid
tipping sod cutter over.
OPERATE SAFELY ON SLOPES
You may cut sod any direction on slopes, however, make sure
you do this carefully. Cutting on slopes can be dangerous. To
avoid any accidents, make sure to leave yourself room to
correct the problem if one arises. Always park your sod cutter
on level ground.
PRACTICE SAFE MAINTENANCE
Keep all machine parts in good condition and fastened in
place. Fix damages immediately. Replace worn or broken
parts. Whenever you work on the sod cutter, disconnect spark
plug wire.
START ENGINE SAFELY
Make sure hands and feet are out of the way of moving parts
when starting engine.
WARNING
KEEP HANDS & FEET AWAY
FROM MOVING PARTS
ENGINE STARTING
PROCEDURES
NOTICE: There are two locations on this engine that require
oil, both the crankcase and the transmission
(gearbox). Running the engine or gearbox with a low
oil level can cause engine damage. Refer to the
engine manual for complete engine information
and recommendations.
ENGINE OIL LEVEL CHECK
1. BEFORE CHECKING ENGINE:
make certain the engine is level
the engine switch is in the OFF position
the sod cutter blade is NOT engaged
the drive wheels are disengaged.
2. Remove the filler cap/dipstick and wipe it clean.
3. Insert and remove the dipstick without screwing it
into the filler neck. Check the oil level shown on the
dipstick.
4. If the oil level is low, fill to the edge of the oil filler
hole with the recommended oil. SAE 10W-30 is
recommended for general use. Refer to engine oil
recommendations in engine manual for other
viscosities and information.
5. Screw in the filler cap/dipstick securely.
TRANSMISSION OIL LEVEL CHECK
1. Check the transmission oil level with the engine
stopped and in a level position.
2. Remove the filler cap/dipstick and wipe it clean.
3. Insert and remove the dipstick without screwing it
into the filler hole. Check the oil level shown on the
dipstick.
4. If the oil level is low, add oil to reach the upper limit
mark on the dipstick. Use the same oil that is
recommended for the engine, SAE 10W-30.
5. Screw in the filler cap/dipstick securely.
ST
ARTING ENGINE
1. Turn fuel cock to the "open" position.
2. Turn choke on (closed).
3. Turn ignition switch to "on".
4. Move throttle lever on engine to half throttle position.
5. Pull recoil starter rope until engine starts.
6. After engine is warm, turn off choke (open).
7. Allow engine to run one minute before cutting sod.
8. Check engine rpm setting before operating. DO NOT
exceed 3600 rpm.
STOPPING ENGINE
1. Turn throttle to "slow" position.
2. Turn off ignition switch.