Filter
Top Products
1
PRE-DELIVERY CHECK LIST
Check the following before you deliver the sod cutter to the
customer.
1. Guards and shields fastened in place.
2. Decals fastened and legible.
3. Tire pressure.
4. Gas lever on engine turned on.
5. All eight lubrication points greased.
6. 2:1 gearbox oil level.
7. Engine oil level.
8. Air cleaner.
9. Touch up scratches.
10. Chain tight.
11. Engine belt tight.
12. Levers working properly.
13. All controls.
14. Add fuel, start engine, test run.
DATE SET UP __________/__________/__________
DELIVERY CHECK LIST
Review the operators manual with the customer.
Explain the following:
1. Classen Mfg., Inc. warranty.
2. Safe operation and service.
3. How to use controls.
4. Operating the machine correctly.
5. Transporting the sod cutter.
6. Correct fuel and lubricants.
7. Daily and periodic inspections.
8. Changing oil after break-in period.
9. Servicing the sod cutter regularly and correctly.
10. Classen Mfg., Inc. parts and service.
11. Give the customer the operators manual and
encourage customer to read it.
DATE DELIVERED __________/__________/__________
SIGNATURE _______________________________________
INTRODUCTION
THANK YOU
Thank you for purchasing the Classen Model SC-20, SC-18, or
SC-12 sod cutter.
READ THIS MANUAL
Read this manual carefully to learn how to operate sod cutter
correctly. Failure to do so could result in personal injury or
equipment damage.
This manual should be considered a permanent part of your
sod cutter and should remain with it if you sell it.
WARRANTY
Refer to back page.
MEASUREMENTS
U.S. units of measure are used in this manual.
SERIAL NUMBERS
Write frame and engine serial numbers, plus model numbers in
"Owners Record" section below. Your dealer needs these
numbers when you order parts. The serial number is located on
a sticker on the center section of the frame.
DIRECTIONS
"Right Hand" and "Left Hand" sides of the sod cutter are
determined by facing the back of the sod cutter as you would
operate the machine.
OWNER’S RECORD
DATE PURCHASED _________________________________
SOD CUTTER MODEL NUMBER______________________
SOD CUTTER SERIAL NUMBER______________________
ENGINE MODEL NUMBER __________________________
ENGINE SERIAL NUMBER___________________________