Filter
Top Products
SKU 94866 For technical questions, please call 1-800-444-3353 PAGE 11
To Assemble The Vacuum Unit:
1. Remove the Protection Cover (7) by turning it counterclockwise. (See Figure F.)
2. Insert the Vacuum Pipe Center Piece (8) onto the Housing (14). Then, turn the
Vacuum Pipe Center Piece clockwise to lock it in position. (See Figure F.)
3. Insert the Vacuum Pipe End Piece (9) onto the Vacuum Pipe Center Piece (8).
Then, turn the Vacuum Pipe End Piece clockwise to lock it in position.
(See Figure F.)
4. Check to make sure the zipper is closed on the Vacuum Bag (11). Then, slide
the Vacuum Bag onto the Bag Connector (10).
5. Insert the Bag Connector (10) onto the Housing (14). Then, turn the Bag
Connector clockwise to lock it in position. (See Figure F.)
BAG CONNECTOR
(10)
VACUUM BAG
(11)
HOUSING
(14)
VACUUM PIPE END PIECE
(9)
VACUUM PIPE CENTER PIECE
(8)
FIGURE F
OPERATING INSTRUCTIONS
To Operate The Blower:
1. Plug the Power Cord/Plug (13) into the nearest 120 volt, grounded, electrical
outlet. (See Figure E.)
2. Hold the unit firmly by the Upper Handle (1) and Lower Handle (2).
(See Figure E.)
3. Turn the Power Switch (4) to its “ON” position. (See Figure E.)
POWER CORD/PLUG
(13)
UPPER HANDLE (1)
LOWER HANDLE
(2)
POWER SWITCH (4)
4. While holding the unit, move the Blower Pipe End Piece (6) from one side to
another keeping a distance of about four inches from the ground surface. Then