Filter
Top Products
SKU 91761 For technical questions, please call 1-800-444-3353. Page 3
10. Warning: Locate Trelllis in a spot that is flat without an uneven surface, away from
electrical wires. Caution: Heavy winds could make the Trellis unstable.
11. Always distribute objects on Bench evenly. Uneven weight distribution could
cause toppling. Do not allow children to climb on the Trellis.
Warning: The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions and situations that may occur. It must
be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the following parts are included. If any parts are
missing or broken, please call Harbor Freight Tools at the number on the cover of this
manual.
Assembly Instructions
1. Assemble all parts on a smooth surface to avoid scratching. These parts fit
together and no hardware is required.
2. “Ladder”Assembly: Use Cross Beams (2) and Bars (3) to form “ladder”.
Set aside.
See Figure A.
3. “Side Lattice” Assembly: Use four Bars (4) (horizontally), three Bars (5)
(vertically) with two Bars (11) (horizontally) at the top and bottom to build the
“lattice” assembly. Repeat instructions for the second side “lattice”.
See Figure B.
4. Still working with the parts on the ground, fit the Support Bar (7) between
the Posts (6). Fit the side “lattice” assembly between the two Posts (6). Repeat
for second side, “lattice” with Posts. Be sure all connections are secure.
See Figure B.
Figure A
Figure B
Cross
Beams (2)
Bars (3)
Post (6)
Bars (4)
(horizontal)
Bars (11)
(horizontal)
Bars (11)
(horizontal)
Bars (5)
(vertical)
Support Bar
(7)