Page 10 of 17 LED Followspot 75ST User Manual (Rev. 04)
Configuration
(DMX)
Set this product in DMX mode to control it with a DMX controller.
1. Connect this product to a suitable power outlet.
2. Turn this product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX
input socket of this product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you
could restrict the access to some of the product’s channels.
The LED Followspot 75ST uses up to 3 DMX channels in its 3-channel DMX mode,
which defines the highest configurable address to 510.
If you are not familiar with the DMX protocol, you may refer to the DMX Primer section in
the Technical Information chapter.
To select the starting address, do the following:
1. Press <FUNCTION SELECT> until 001 shows on the display.
2. Press <UP> or <DOWN> to select your starting address.
DMX Channel Assignments and Values
3-CH
Channel
Function
Value
Setting
1
Dimmer
000 255
0~100%
2
Color
000 031
White
032 063
Dark Blue
064 095
Yellow
096 127
Purple
128 159
Green
160 191
Red
192 223
Light Blue
224 255
Orange
3
Strobe
000 255
0~100%