Filter
Top Products
Technical Information
Q-Spot™ 560-LED User Manual Rev. 08 -25-
Troubleshooting Guide
Symptom
Cause(s)
Action(s)
Product does not light up
Dimmer fader set to “0”
Increase the value of the dimmer channel
color fader set to “0”
Increase the value of the color channel
All colors in CUSTOM mode
are set to “0”
Increase the values of the colors
No power
Verify external power circuit and wiring
Faulty internal power supply
Send unit for repair
Faulty main control board
Continuous gobo
rotation
Gobo plate #1 missing or in wrong
location
Verify Gobo plate #1 is correctly installed
One of the LEDs does
not work
Faulty LED
Send unit for repair
Faulty LED module
Faulty LED driver
Circuit breaker/fuse
keeps tripping/blowing
Excessive circuit load
Reduce total load placed on the electrical circuit
Short circuit along the power wires
Check electrical wiring
Unit does not power up
No power
Check for voltage on outlet
Loose or damaged power cord
Check power cord
Blown fuse
Replace fuse
Faulty internal power supply
Send unit for repair
Unit does not respond to
wired DMX or responds
erratically
Wrong DMX addressing
Check unit addressing
Damaged DMX cables
Check DMX cables
Wrong polarity on the controller
Check polarity switch settings on the controller
Loose DMX cables
Check cable connections
Non DMX cables
Use only DMX compatible cables
Bouncing signals
Install terminator as suggested
Long cable / low level signal
Install an optically coupled DMX splitter before a
long section of cable or right after the unit with
the strong signal
Too many units
Install an optically coupled DMX splitter after unit
#32
Interference from AC wires
Keep DMX cables separated from power cables
or fluorescent/black lights
Faulty DMX interface board
Send unit for repair
Faulty Display/Main board
Send unit for repair
If you still experience technical problems after trying the above solutions or if you
need to send the unit for repair, contact CHAUVET® Technical Support.