Filter
Top Products
4BAR™ Flex User Manual (Rev. 3) Page 13 of 17
Footswitch
Operation
The included footswitch provides quick access to the preset colors, color change
programs, and triggering via the onboard microphone on the 4BAR™ Flex:
1. Power on the fixture.
2. Connect the footswitch to the 4BAR™ Flex via the 4-pin connection cable with plug.
3. Press pedal #1 (Preset) to activate control. When this is operating properly, the
LEDs on the 4BAR™ Flex will light white (first function on pedal #1).
Pedal Sub-option Function
1
(Preset)
1 x press White
2 x press Red
3 x press Green
4 x press Blue
5 x press
Yellow
6 x press Magenta
7 x press Cyan
8 x press
Color change every second in a
continuous loop
9 x press
Color change every three seconds in a
continuous loop
2
(Sound On)
1 x press Sound controlled
3
(Blackout)
1 x press All LEDs off (blackout)
There is no need to modify any settings for the 4BAR™ Flex
before connecting
the footswitch. It will operate properly in any mode.
Plug the master fixture in LAST!
Disconnecting
the Footswitch
In order to properly disconnect the footswitch, please follow these steps:
1. Unplug the footswitch from the 4BAR™ Flex.
2. Turn the power to the fixture off (unplug the power cable).
3. Turn the
power to the fixture on again (plug in the power cable), and the fixture will
properly operate on any one of the three modes.