Filter
Top Products
Introduction
Thank You for purchasing this Acurite
®
product. Please read through this
manual in itʼs entirety to fully enjoy the benefits and features of this
product. Please keep this manual for future reference.
NOTE: A protective film is applied to the LCD at the factory that must be
removed prior to using this product. Locate the clear tab and simply peel
to remove.
Overview
SETUP
SETUP
Battery Choice & Temperature Range
Extended periods of cold temperatures ( below -4ºF / -20ºC ) can cause
alkaline batteries to function improperly. This will cause the outdoor
wireless sensor to stop transmitting temperature readings. Use lithium
batteries in these low temperature conditions to ensure continued
operation for wireless sensors placed outdoors. NOTE: Rechargeable
batteries are not recommended due to higher operating voltages.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY
SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove
battteries from equipment which is not to be used for an extended perid of time. Follow the polarity (+/-) diagram in the battery
compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same
or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in re, as
batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use
rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.
Installing Batteries - Wireless Sensor
Installing Batteries - Display Unit
Remove the battery
compartment cover. Install
2 fresh “AA” batteries as
shown here.
BATTERIES
MUST BE INSTALLED FOR
THE SENSOR TO OPERATE
Remove the battery
compartment cover.
Install 3 fresh “AA”
batteries into the
battery compartment.
Replace the battery
compartment cover.
21
Outdoor
Temperature
Intelli-Time
®
Clock
Month,Date
Pressure
Graph
Outdoor
Humidity
A/B/C Wireless Selection
To allow for more than one weather station and wireless sensor
network to be used in close proximity, the display unit and the
wireless sensor have a small switch labeled “A B C” within the
battery compartments. This switch selects one of 3 wireless modes
to use, and both switchs MUST be set in matching positions (either A,
B, or C) fore wireless communication to take place successfully.
Weather
Forecast
Moon Phase