Filter
Top Products
8
Step 12. Using the blade holder screws(pack
of 11) attach each blade/bladeholder assembly
to the motor.
Using the screwdriver, tighten securely by hand
only.
Step 14. Line up the two clearance holes in the
cap with the two threaded holes on the raised
rim of the switch housing. Press the cap onto
the switch housing to seat the guide pins into
the alignment holes of the switch housing.
Step 15. Using the two (2) 8-32 X
3
/8″ screws
removed in Step 10, install the cap onto the
switch housing.
Tighten securely by hand only.
BLADE HOLDER
SCREWS(2 per blade)
Note: If you have purchased an accessory light fixture for
this fan, please go to Step 16. if not, please continue with
Step 14.
SWITCH HOUSING
MOUNT SCREW
(REMOVED IN STEP 10)
8-32 X
3
/8″
(2)
SWITCH HOUSING CAP
BLADE/BLADE HOLDER INSTALLATION
INSTALLING THE SWITCH HOUSING CAP
SWITCH HOUSING BRACKET/ CAP HARDWARE
SWITCH HOUSING BRACKET
(2)
Step 13. Take the 2 switch housing brackets and snap them
into place in the holes in the switch housing. This is to prevent
any wires getting pushed down near the motor. Make sure no
wires are in the way or pinched in these brackets.
INSTALLING THE SWITCH HOUSING BRACKETS