Filter
Top Products
3
Wi l d e r n e s s
™
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE
THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY
ALLEN SET SCREW
1
⁄
4
-20 x
1
⁄
4
”
(PRE-INSTALLED)
3mm
ALLEN WRENCH
6” DOWNROD
& BALL ASSEMBLYMOTOR COVER
Prepare for fan installation as follows:
Step A. Place the motor cover on the downrod as shown.
Step B. Route the wires from the motor through the
Perma
•
Lock™ downrod and ball assembly.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!
Tip: The downrod has a tapered thread that is designed
to lock completely when correctly installed.
Step C. Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread the
downrod into the motor coupling until it stops turning, this
will take at least four and a half full turns.
Step D. Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
Step E. Slide the motor cover down so that it is flush against
the top of the fan.
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
MOTOR COVER
MOTOR WIRES
DOWNROD & BALL
ASSEMBLY
MOTOR COUPLING
TAPERED THREAD
ALLEN SET SCREW
Step F. Using the three screws provided, attach
the motor cover to the motor. Tighten firmly by
hand only.
6 - 3/8” SCREW
(3)
INSTALLATION INSTRUCTIONS
PERMA•LOCK™ HARDWARE
FAN PREPARTION