Filter
Top Products
13
OUTSIDE USA - SECONDARY SUPPORT ♦ COMPLETING INSTALLATION
Step 16. Attach the fan cable to outlet box cable with the
spring lock hook. Make sure the spring lock is tightly closed.
Step 17. Tuck the wires into the canopy with the wire nuts
pointed upward, so that the white and black wires are on
opposite sides of the canopy and all wires are clear of the
canopy opening. Tuck the extra cable and screw lock hook
into the canopy.
NOTE: International fans and light fixtures are supplied
with plug and socket connectors. Substitute these connectors
for the wire nuts shown throughout this manual.
FAN AND OUTLET
CABLES SECURED BY
SPRING LOCK HOOK
WIRE NUTS
INSTALLED
BLADE SCREW
(3 PER BLADE)
FLAT WASHER
(3 PER BLADE)
BLADE HOLDER SCREW
(2 PER BLADE)
BLADE
HOLDER
BLADE SCREW
(3 PER BLADE)
FLAT WASHER
(3 PER BLADE)
Step 18. Attach the blades to the
blade holders with the three blade
screws and flat washers provided
for each blade. Hand tighten
securely.
Step 19. Install the assembled
blade and blade holder to the fan
motor. Hand tighten securely.
Repete for each assembly.
Step 20. Attach the pull chain fob.
BLADE HOLDER
SCREW
(2 PER BLADE
HOLDER)
FOB
OUTSIDE USA - BLADE & BLADE HOLDER HARDWARE
PROCEED TO PAGE 8.
FOUR SEASONS™ III (OUTSIDE USA INSTALLATION)
OUTSIDE USA - BLADE & BLADE HOLDER INSTALLATION