55
Pa n a m a
®
Ha l o
To hang the fan body in the canopy, hold the fan
bodyrmlyandinserttheballintothecanopyopening.
Check that no wires were pinched. Rotate the fan body
untiltheslotinthenylonballtsintothepinopposite
the canopy opening.
hANGING ThE FAN
PIN
SLOT
BALL
NOTE: Independent control of
the light xture using a W-81 re-
quires an additional power wire
run from the wall switch to the
fan. See Page 10 for wiring.
CANOPY hATCh INSTALLATION
Tuck the wires into the canopy
with the wire nuts pointed upwards,
sothattheWHITEandBLACKwires
are on opposite sides of the canopy
and all wires are clear of the canopy
opening.
Install canopy hatch with the
last canopy screw and lock washer. To
do this, tilt the fan body away from the
hatch opening.
Tighten the screws firmly by hand
only,
TILT THE FAN TO INSTALL
LAST CANOPY SCREW
CANOPY
HATCH
CANOPY
SCREW
LOCK
WASHER
Straighten the fan, then check
to ensure that there is no movement
between the canopy and ceiling
or Hang-Tru ball and top support
shaft.
Fan Weighs 27 lbs
CANOPY ELECTRICAL CONNECTIONS
Wiring Connections
• GREENleads frommountingplate andfanto
GROUNDconductorofpowersource.Securewith
wire nut.
• WHITEwirefromfantowhiteNEUTRALwirein
ceilingxtureoutletbox.Securewithwirenut.
• BLACKpowerwirefromfantoBLACKpowerwirein
ceiling outlet box. Secure with wire nut.
Attach the fan wires to the ceiling fixture
outlet box wiring by twisting the bare ends of the wires
together and then securing with a wire nut. Test that the
connection is secure by pulling on the wire nut. Conect
inthisorder:
2 WHITE WIRES
2 BLACK WIRES
3 GREEN
WIRES