Casablanca Fan Company 66HXXF Outdoor Ceiling Fan User Manual


  Open as PDF
of 10
 
4
crossbar mounting bracket installation
JOIST
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
GREEN GROUND
WIRE
CEILING FAN
APPROVED
WIRING BOX
RIDGE SIDE
DOWN
APPROVED OUTLET
BOX HARDWARE
Note: After removing the old xture, check the outlet
box to insure that it is supported by a joist or beam
across its upper surface. If not, a 2” x 4” stud must
be installed.
 Remove the knockout plug in the center of the
outlet box or drill a
1
/2”holeforthelagscrewtopass
through. Then drill a
1
/4”guideholeintothejoistorbeam
toadepthof3”.
 Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket as shown. Attach the
crossbar mounting bracket to outlet box with screws pro-
vided, assuring that the outlet box wires are not pinched
by the washer.
CAUTION: To reduce the risk of personal
injury, use only the mounting hardware pro-
vided with the approved outlet box to install
the crossbar mounting bracket.
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE ONLY.
 With the large washer attached, pass the lag
screw through the center hole of the crosbar mounting
bracket and screw into guide hole. Tighten until outlet
boxisrmlymountedtobeam.Thisboxmustbermly
secured to the ceiling. We recommend that the ceiling
xtureoutletboxbeofsufcientcapacityenablingit
tosupporttheweightoffanandlightxtureunderany
conditions.
LAG
SCREW
LAG SCREW INSTALLATION
LARGE
WASHER
CANOPY hARDWARE
CANOPY LOCK WASHER
(4)
CANOPY SCREW (4)
CANOPY
CANOPY
HATCH
 previous next