Campbell Hausfeld PW2570 Pressure Washer User Manual


 
5
Pressure Washer
www.chpower.com
UNPACKING
Remove the equipment and all parts from the carton. The
carton should contain the following:
One pressure washer (pump, engine, cart base)
One cart handle assembly
One spray gun
One lance
One tip holder with 2 spray tips. Additional tips available
for purchase, see Page 13
One high pressure hose
One pack of nuts, bolts, and manuals
If any parts are missing, DO NOT RETURN THE UNIT TO THE
RETAILER. Know the unit’s model number (located on the
serial number tag on the pressure washer frame) and call
1-800-330-0712 for replacement parts.
After unpacking the product, inspect it carefully for any
damage that may have occurred during transit. Make sure to
tighten fittings and bolts before using the pressure washer.
Do not operate the unit if it’s
damaged during shipping, handling,
or use. Damage could result in bursting and cause injury or
property damage.
Figure 2 - Pump hook up
Garden
Hose
Pump
Inlet
Pump
Outlet
High
Pressure
Hose
Chemical Injector
Hose Barb
Thermal
Relief
Valve
Brass
Swivel
Adapter
Figure 3 - Brass swivel adapter
Connect This
End To Garden
Hose
Washer
Washer With
Filter Screen
Connect This
End To Pump
Figure 4 - Connect the brass swivel to
the pump
Brass Swivel
Adapter
Pump Inlet
Pre-Operation
ASSEMBLY
1. Slide the handle assembly over the lower legs of the cart
base. Use the supplied nuts and bolts to secure the handle
to the legs. See Figure 1.
2. Brass Swivel Adaptor (See Figure 2). If it’s not already
attached to the pump inlet, assemble the brass swivel
adapter and attach it to the pump inlet (See Figure 3 and
Figure 4). Be sure to connect the correct side of the brass
swivel adapter to the pump.
Figure 1 – Assemble Handle