Filter
Top Products
you avoid applying too much
concentrated spray to the surface
which could cause damage.
3. Detergent Application
Note: Use only detergents formulated
for pressure washers. Test detergent in
an inconspicuous area before use.
1. Unscrew caps from detergent
bottles and fill bottles with
detergent.
Note: Bottles operate
independently and can be filled
with different detergents.
2. Replace caps on bottles.
3. Select detergent to be used by
turning detergent selector knob
on front of unit to either “I” or
“II.”
4. Slide adjustable fan nozzle to low
pressure position and apply
detergent so that it thoroughly
covers the cleaning surface. Apply
from bottom to top to prevent
detergent from sliding down and
streaking. Wait a couple of
minutes for the detergent to
break down dirt and grime. This
is a good time to use a brush to
lightly scrub heavily soiled areas.
Never allow detergent to dry on
cleaning surface.
Note: Detergent injection may not
work with extension hose or
replacement hoses longer than 25 feet.
5. To rinse or return to high
pressure, release trigger and slide
nozzle to high pressure position.
4. Final Rinse
Start final rise at bottom and work
upward. Make sure you thoroughly
rinse the surface and that all detergent
has been removed.
5. Shutdown
1. Be sure all detergent is flushed
from system.
2. Turn off motor.
3. Turn off water supply.
4. After motor and water supply are
turned off, trigger gun to
depressurize system.
5. After each use, wipe all surfaces
of the pressure washer with a
clean, damp cloth.
NEVER turn water supply off before
turning motor off. Serious damage
could occur to the pump and/or motor.
NEVER disconnect high pressure
discharge hose from machine while
system is pressurized. To depressurize,
turn motor off, turn water supply off
and squeeze gun trigger 2–3 times.
8
www.chpower.com
Operating Instructions and Parts Manual