Filter
Top Products
Page 30 2008 Portable Spa Owner’s Manual
LTR20081000, Rev. B
Cleaning and Maintenance
All-Purpose Cleaner (Spa Finish cleaning)
Cal Spas™ All-Purpose Cleaner is an
essential part of maintaining your spa’s
nish. Through normal use, the spa’s
nish can accumulate dirt, oil, and calcium
causing a rough feel and unsightly scum
lines. Cal Spas™ All-Purpose Cleaner
is a low detergent, non-abrasive cleaner
specically formulated to clean the spa
without damaging its acrylic nish.
The most effective solution to minimize
cleaning time is prevention. When the
following steps are followed, the spa’s nish will actually
start to resist most of the elements that cause calcium
build-up and make scum line clean up easier.
Prior to Spa Start-Up and Relling
Spray Cal Spas™ Multi-Purpose Cleaner directly on
to the spa’s nish.
Wipe clean with a clean soft cloth.
Repeat on heavily calcied areas.
Wipe spa thoroughly with a wet sponge, rinsing
often with a bucket of clean water.
Allow spa to dry completely.
Apply a coat of Cal Spas™ Fast Sheen to the spa’s
entire nish with a soft towel or sponge.
Allow Fast Sheen to dry until white and powdery.
Buff clean with a soft cloth, rotating frequently.
Periodic Maintenance
Spray Cal Spas™ Multi-Purpose Cleaner directly to
the spa’s nish.
Wipe clean with a clean soft cloth.
Wipe spa thoroughly with a wet sponge, rinsing
often in a bucket of clean water.
Cal Spas™ Multi-Purpose Cleaner should not be
sprayed directly into the spa water. Incorrect usage of
this product will cause water clarity issues.
Fast Sheen (Spa Finish
Protecting Wax)
Cal Spas™ Fast Sheen is an essential
part of maintaining your spa’s nish.
Through normal use, the spa’s nish
can accumulate dirt, oil, and calcium,
causing a rough feel and unsightly scum
lines. Cal Spas™ Fast Sheen is a non-oil
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
Remove the lter baskets and lters.
Drain your spa completely as described in the
instructions above.
Remove drain plugs from the front of the pumps.
Disconnect the unions from both sides of the pump.
Use a wet/dry vacuum to blow any remaining water
out of the jets and equipment area.
Cover your spa with a good spa cover and an all-weather
tarp to ensure that neither rain nor snow enters the spa.
Cleaning the Cover, Shell and
Pillows
Due to the constant punishment your spa cover and
pillows receive, you should protect them by applying
Vinyl and Leather Cleaner as part of your monthly
maintenance plan. Cal Spas™ Vinyl and Leather
Cleaner is specically designed to protect spa covers
and pillows from chemical and ultraviolet light damage. It
accomplishes this without leaving an oily residue behind
that is normally associated with common automotive
vinyl protectants.
Use of Vinyl and Leather Cleaner
Cal Spas™ Vinyl and Leather Cleaner
should be used sparingly. Incorrect
usage may cause water clarity issues.
Spa Covers
Remove spa cover from spa.
Allow spa cover to dry completely.
Spray Vinyl and Leather Cleaner
to cover evenly and wipe dry.
Allow spa cover to dry completely.
Reinstall cover on spa.
Pillows
Wipe pillows dry with a soft cloth.
Carefully spray Vinyl and Leather Cleaner directly
onto pillow.
Wipe pillows dry.
Allow pillows to dry completely.
Warning: Do not use automotive vinyl protectants on
spa covers or pillows. These products are generally oil-
based and will cause severe water clarity issues that are
difcult to correct.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
1.
2.
3.
4.