Filter
Top Products
Selecting an Eyepiece:
1. You should always start viewing with the lowest power eyepiece, which in this case is the 20mm lens. Note:
the base power of each eyepiece is determined by the focal length of the telescope objective lens, which for
this model is 750 mm. A formula can be used to determine the power of each eyepiece: telescope
OBJECTIVE lens focal length EYEPIECE focal length = MAGNIFICATION (e.g. Using the 20 mm lens,
the calculation would look like this: 750 mm ÷ 20mm = 38x or 38 power.)
2. Included with this telescope is a Barlow lens. Barlow lenses are used to double or triple the power of your
telescope. Place your Barlow between the focusing tube and the Penta Mirror. Note: The Penta Mirror
Assembly when used in conjunction with the Barlow Lens and Eyepiece as shown on diagram will
yield an effective doubling power of the magnification already achieved with the Barlow and Eyepiece
configuration alone. The magnification calculation would look like this: 750 mm ÷ 20mm = 38 power. 38
power x 3=114 power. 38 x 3 x 2=228 power. (See Intended Configuration Diagram).
Focusing Telescope:
1. After selecting the desired eyepiece, aim main telescope tube at a land-based target at least 200 yards away
(e.g. A telephone pole or building). Fully extend focusing tube by turning Rack and Pinion Focusing Mechanism
(15).
2. While looking through selected eyepiece (in this case the 20 mm), slowly retract focusing tube by turning Rack
and Pinion Focusing Mechanism until object comes into focus.
Viewing Land-Based Objects:
1. As described above, the Erecting Lens will correct the normally upside down and reversed image so that you
can easily enjoy observing land-based objects through your telescope.
2. Simply insert the Erecting Lens into the focusing tube of the telescope followed by the penta mirror, then
insert an eyepiece into the penta mirror. (See Intended Configuration Diagram).
3. Repeat focusing directions as described above except that you will be looking through the Erecting Lens and
eyepiece instead of just the eyepiece.
Aligning Finderscope:
Look through main telescope tube at low power and establish a well-defined stationary target. Looking through
red dot finderscope, alternate tightening each adjustment wheel (at rear and left side of finderscope) until the red
dot of finderscope is precisely aligned and centered on the same object being viewed in main telescope tube.
See finderscope page.
Now, objects located first with the Finderscope (18) will be centered in the field of view of the main telescope.
Balancing the Telescope
1. Arrange the telescope so that the telescope body is horizontal to the floor (latitude of 0°). Loosen the Right
Ascension Lock (4). The telescope should now turn freely about the polar axis. Rotate the telescope about the
polar axis so that the Counterweight Shaft (5) is parallel to the ground (horizontal).
2. Loosen the Counterweight Lock Screw (located on the
counterweight), and slide the Counterweight (6) along the
shaft until the telescope remains stationary without drifting
rotationally about the polar axis. Tighten the Counterweight
Lock Screw, locking the Counterweight into position.
3. Now balance the telescope about the Declination Axis.
Loosen the Declination Lock Knob (3) and the Cradle Lock
Knobs (fig. 3) so that the telescope can slide freely inside the
Cradles. Slide the telescope up or down inside the rings until
Fig. 3
Cradle (20)