Filter
Top Products
SECTION I
INTRODUCTION AND DESCRIPTION
1-1 INTRODUCTION
We are pleased to have you as a Bush Hog cus-
tomer. Your TD-1100 Finishing Mower has been
carefully designed to give maximum service with
minimum down time. This manual is provided to give
you the necessary operating and maintenance
instructions for keeping your mower in top operating
condition. Please read this manual thoroughly.
Understand what each control is for and how to use
it. Observe all safety precautions decaled on the
machine and noted throughout the manual for safe
operation of implement. If any assistance or addi-
tional information is needed, contact your authorized
Bush Hog distributor.
NOTE
All references made to right, left, front, rear, top or
bottom are as viewed facing the direction of travel
with implement properly attached to tractor.
6
The caster wheel arrangement along with the flexi-
ble, floating deck attachment and the standard front
mounted rollers, all work together to give an even
cut and minimize scalping.
NOTE: The inside rear wheel on the wing mower
decks and both the front wheels on the rear mower
deck are rigidly mounted and are not designed to
caster.
Power from the tractor is transmitted through a
telescoping driveline to a belt drive and gearbox
arrangement which allows either wing unit to be fold-
ed up to 30° while still operating. Power is passed to
the spindle housings by a B-section, Kevlar reinforced
belt. Drivetrain protection is provided by belt slip-
page.
1-2 DESCRIPTION
The TD-1100, Figure 1-1, is designed for turf main-
tenance applications where a high quality of cut on
turf grasses is required.
Figure 1-1 TD-1100
Technical Specifications
Specification TD-1100
Cutting Width 11’
Transport Width 78”
Cutting Height 3/4 to 4-1/2”
Blade Tip Speed (FPM) 16,100 FPM
Required Tractor Horsepower 30 HP min.
Wing Flex 30° up, 10° down
Belts Kevlar
Driveline Size Cat. IV 80° CV (main),
Cat. III (wing)