Filter
Top Products
ASSEMBLY
RMB 1660 11/10 Assembly Section 3-7
© 2010 Alamo Group Inc.
ASSEMBLY
• Replace the stabilizer quadrant pin and secure with
the clip pin.
NOTE: The quadrant pin must be fitted in the lowest
hole on the stabilizer in order that it acts as a “Bottom
Stop”. This will prevent the machine from dropping
when stopped and permit the tractor’s in-built transport
protection system to function correctly during operation
and transportation.
• Ensure the tractor’s linkage is in “Position Control”
and the linkage raised sufficiently to hold the sickle
bar at the correct height and remove the load from
the quadrant pin
NOTE: Never fit the quadrant pin in a location hole that
locks the stabilizer as this can cause damage to the
machine and/or tractor.
• Adjust the top link to bring the machine frame into
the vertical position.