Filter
Top Products
E. Fasten mast supports and upper flex link to
mast halves using 1/2 x 5” capscrew, pivot tube and
locknut.
F. Place two long spacers on the caster stems
and insert into caster arms. Place two long spacers
and two short spacers on the caster stem above the
caster arms. This arrangement will give a cutting
height of approximately 3-1/2 inches. Secure with
lynch pin retainers. With weight of cutter resting on
all four wheels, ensure that cutter is level. Tighten all
bolts on mounting brackets.
G. Fill gearbox with EP80W-90 gear oil until
oil level is at check plug on side of gearbox
housing. (Capacity is 1 quart) Replace solid fill
plug with breather plug supplied in operator’s
manual package.
15
RFM 60
Gearbox Oil Level
Check Plug