Filter
Top Products
ASSEMBLY
5145 01/11 Assembly Section 3-9
© 2011 Alamo Group Inc.
ASSEMBLY
Detaching Quick Attach Device
To avoid injury during installation of the loader attachment, do not allow bystanders within 10
feet of loader or attachment.
1. Locate tractor and loader can level ground.
2. Lower boom arms until the attachment is level and resting on ground.
3. Place tractor in neutral, set parking brake, shut off tractor engine and disengage quick attach device latch
pins by moving handles to unlatch position (refer to Figure Asm-L-0039).
4. Start tractor engine, release brake and extend bucket cylinders while slowly backing the tractor away from
attachment, until quick attach disengages from attachment.
Assembling Quick Attach Device
Quick attach device can be installed using tools ordinarily available.
Torque all hardware to specifications listed in loader operator’s manual.
Shut off the tractor engine and engage the tractor brakes during installation.
Only quick attach, skid steer compatible attachments can be used with the quick attach device. Pin on style
attachments can be used on the loader, but necessitate removal of the quick attach device and relocation of
the bucket level indicator.
All references to left and right used in these instructions are as they would appear to the operator standing at
the rear of the unit facing forward.
1. Quick attach device is pre-assembled at the factory.
2. Unband the quick attach device and wood blocks. (Figure Asm-L-0012)