Filter
Top Products
SAFETY
5145 01/11 Safety Section 1-9
© 2011 Alamo Group Inc.
SAFETY
Do not use an attachment that is not securely attached to the quick
hitch, The attachment could fall resulting in severe crushing injuries
or death to the operator or bystanders.
• Rotate both hitch pin levers down to the locked position. You should feel a firm
resistance when locking the levers down. The pins must extend through the slots in
the bottom of the attachment bracket.
• Examine the fit between the quick hitch and the bottom of the attachment bracket.
The pins must extend through the slots in the bottom of the attachment bracket. The
tapered side of each pin must be firmly wedged against the surface of the slot on
the bottom of the attachment bracket. The attachment bucket should fit snugly
against the bottom of the quick hitch bracket. If there is a gap of more than 1/8” or if
the pins are not firmly seated do not use the attachment. Contact your dealer before
using the attachment.
• On level ground, tilt the attachment down 90° degrees and lower it to the ground.
Lower the loader further to slightly raise the front of the tractor off the ground. Drive
the tractor in reverse while the attachment is on the ground for 20-30 feet to ensure
the attachment does not disconnect. If the attachment disconnects during this
process, discontinue the use of the attachment and contact your dealer.
NEVER walk or work under or allow any person to be underneath a
raised loader or attachment.
(SL-15)
Do not operate the loader from the ground. Operate the tractor and loader only while seated
in the tractor seat with the seatbelt fastened. The loader could fall crushing a person
resulting in serious injury or death.
(SL-16)
Use extreme care when piling material above 6 feet high. Material
could shift and fall onto the operator or bystanders. The material could
crush or suffocate the operator or bystander resulting in serious injury
or death.
(SL-17)